Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
OTA capture dont show the CS procedure running 0

Hi am trying to use Nrf54l15 as a controller with an external host for the Channel sounding feature. I can receive CS subevents from the NRF controller, but the same thing...
0 views

0 replies

Started a few seconds ago
by Abhinav152
Not Answered
Always run old firmware after OTA after changing flash size 0

HI ALL, nrf54l15dk,v2.8.0,peripheral_uart demo and no changes have been made. Then add the following content to prj.conf sysbuild.conf mcuboot.conf At this...
7 views

0 replies

Started 40 minutes ago
by 666
Not Answered
Request for blog authoring permission 0

Hi Nordic Team, I recently joined the DevZone and I’m interested in contributing to the blog. I’d like to write technical articles and tutorials related to Nordic products...
11 views

0 replies

Started 1 hour ago
by jason58
Not Answered
how peripheral get pc num lock\caps lock state? 0

Hi, I am programming with ncs v2.9.0, nrf52833 chips. I am going to get pc keyboard led state in my custom board throutgh BLE. This is my report map,but cannot get data...
10 views

0 replies

Started 1 hour ago
by Martin Evans
Not Answered
Bus Fault caused by write data to fds 0

I'm developing my application with nrf 52832 and nrf SDK v17. I know NCS is more powerful. I'm currently learning how to use it. But now.I still need my application with...
20 views

0 replies

Started 5 hours ago
by Chaoyue Ying

Recent in Nordic blog

Programming the nRF51822 Beacon Kit with the nRF51DK

Stefan Birnir Sverrisson

One way to program the nRF51822 Bluetooth Smart Beacon Kit is to use the nRF51 DK. This gives you a full scale development platform (the nRF51 DK). This blog will go thru the steps needed to program…
- 7 May 2015
Bluz, a cloud connected Bluetooth LE development kit based on the nRF51822, is live on Kickstarter

eric ely

Bluz is a brand new development kit that brings Bluetooth LE to the internet. We have paired up with Spark and ported their FW to the nrf51822, allowing Bluz to be controlled and programmed over the…
- 15 Apr 2015
nRF51 current consumption for common scenarios

Stefan Birnir Sverrisson

The following is the estimated nRF51 current consumption during advertising with the DCDC disabled. Advertising 1: TX power: +4dBm adv interval: 20ms (minimum advertising interval in normal adversising…
- 14 Apr 2015
Building kernel for RPi2 with bluetooth_6lowpan for Raspbian

Håkon Alseth

Building kernel for RPi2 with bluetooth_6lowpan In this guide, you will have two choices: Cross-compilation build Native build Choose the one that fits your needs. Cross-compilation is…
- 9 Apr 2015
Debugging with Real Time Terminal

FormerMember

In SDK 12.0.0 or later, logging/debugging over RTT is built in to the logger module NRF_LOG. To enable logging over RTT, "check" the NRF_LOG_BACKEND_SERIAL_USES_RTT option in sdk_config.h in the configuration…
- 8 Apr 2015
Accessing the BLE mesh via the particle.io (spark.io) cloud

David Edwin

Hello. I was spending the last few days to implement an interface to access the BLE mesh via the Internet. The mesh consists of devices with LEDs, which then could be turned on and off in my browser.…
- 1 Apr 2015