When both ethernet and WiFi are supported on one MCU (with both sharing the same L2 implementation, only one network device being active at a time), does it matter if both...
we have a custom board with nRF9160, when using GNSS we configured it to periodic mode with 120 second interval, most time it works fine but every once in a while (like every...
Hello everybody! It's my first question and I'm new at mcu programming. I hope for your understanding!
I have a task: count seconds using a counter and display them on a...
Since I need zephyr version 4.0 or newer, I tried updating my project to the nRF Connect SDK v3.0.0 as well as the toolchain. I know that they are not fully released yet....
Hello,
I am a beginner when working with nRF. I am trying to run the l4_e3 solution code, but it doesn't seem to work. I can connect via BLE, but nothing is being shown...
Recently, Google introduced some news about Eddystone. At the same time, we released a first implementation of the new specification on GitHub to get developers started. I would like to share some insights…
We in the Nordic Support team have created an online power profiler to estimate the power consumption during a BLE event with different parameters. The profiler gives you information about the different…
#Why use trace
"Embedded Trace Macrocell (ETM) allows to capture information on the processor’s state without affecting the processor’s performance. Microcontrollers that include an ETM allow detailed…
###Other relevant posts
A concise guide to equipment setup, and how to use the development kit for current measurements can be found here: Measuring current with PCA10040 v0.9.0
A post that describes…
When designing a PCB with nRF51, nRF51822 or nRF51422, there are some rules that should be followed in order to get a good working radio/system, with a maximized range.
General rule
The RF part of the…
2019-02-08: Updated tutorial to cover nRF5 SDK version 15.2.
Introduction
Scope
The following topics will be included in this tutorial:
Configuration of the Scheduler library.
Using the scheduler with…
Scope
Topics that will be covered include:
Before we begin
Necessary equipment and software
Necessary prior knowledge
Setting up the example projects
Background theory
Central and peripheral roles…
2018-11-23: Updated tutorial to cover SDK version 15.2.
2019-02-08: Improved example project (SDK 15.2) and updated instructions accordingly.
Introduction
Scope
The following topics will be included in…
Before we begin
Scope
Topics that will be covered include:
Before we begin
Necessary equipment and software
Necessary prior knowledge
Some basic theory
The Generic Attribute Profile (GATT)
Services…