Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Connecting a flexible board to a rigid board using an FPC connector 0

Hello everyone! I'm designing a flexible PCB and I'm a bit confused with the stack up. I've seen that the nRF52840 development board has an NFC antenna with the following...
- development
- antenna
- nrf5 sdk
- nrf52840
- nfc
- hardware
3 views

0 replies

Started 10 minutes ago
by Natalia_NPL
Not Answered
Build with MCUBOOT and only provide public key 0

Hi We have a third party that develops some of our products, and this third party does not release their source code. However, we would like to sign our binaries with a...
13 views

0 replies

Started 1 hour ago
by robertp
Not Answered
Nordic SDK build matter project confusing 0

When I download and install NCS2.8.0 SDK, I want to build matter project(ex: light bulb), do I need to install matter build environment referring this link( matter build ...
12 views

0 replies

Started 1 hour ago
by susepc
Not Answered
Pin connection for UART and SPI for Thing:91 0

Hello, I need to connect the Thingy:91 to an MCU via UART and/or SPI bus. I need help to identify the pins for communications for: SPI: CSK, CS, MISO, and MOSI UART...
- Evaluation
- spi
- Other
- hardware
13 views

0 replies

Started 3 hours ago
by RamizB
Not Answered
When using external flash, calling Device_is_read returns a failure 0

Hi: I use ncs v2.8.0, using external flash(w25q128). this is test flash project. And this log: Device_is_read returns a failure. But flash read/write successful...
17 views

0 replies

Started 5 hours ago
by john.liu

Recent in Nordic blog

Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016

Latest guides

Bluetooth low energy: Bluetooth low energy Advertising, a beginner's tutorial

MartinBL

Before we begin Table of context Before we begin The "Hello world" example Advertising RSSI Addresses Address types Advertising types Bonding Advertising data Scan response data Change Log 2018…
- 31 Mar 2015