Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Zephyr Eddystone example is connectable just once. How to fix? 0

Zephyr Eddystone example is connectable after power on of nrf52833 board. But after disconnect it becomes non connectable. How to fix it? And how to change advertisement interval...
684 views

0 replies

Started over 2 years ago
by Zheckiss
Not Answered
Looking for an english or hungarian speaking developer 0

We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk. Please, contact me if you are interested.
749 views

0 replies

Started over 2 years ago
by Norbert Ambrus
Not Answered
openthread and mcumgr with uart0 and uart1 via usb 0

Close, this is being discussed here: Thanks
636 views

0 replies

Started over 2 years ago
by JuanAlm
Not Answered
Where do I find the presentation for the Building more reliable Bluetooth LE products with Memfault webinar? 0
630 views

0 replies

Started over 2 years ago
by Ali Aljaani
Not Answered
nRF Connect for Desktop advertising restart after disconnect 0

Hi After each connection, I should press Alt-A. Is it possible to add a feature so the advertising will restart automatically after the connection is finished?
653 views

0 replies

Started over 2 years ago
by Mike Tuev R9FT

Recent in Nordic blog

nRF52 Range Extension with RFaxis' RFX2411N

Floyd Ashbaugh

External Power Amplifiers and LNAs easily connected to the nRF52 series device for high power extended range operation. Data sheets, white papers, schematics and layout information available at link t…
- 26 Jan 2016
Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016