Help me please!!!
nRF52840 DK stops to scan after 3 hours working.
Project is based on central_nordic_uart_service.
Scan params
it works fine 3 hours and then BLE...
Hi everyone.
I catch a terrible issue
When I use nrf52840 and NUS Android app and had for a short time a bad rssi (because of long distance between Android and SoC) and...
Hello
We need to scan for more than 8 devices, so we can't use witelist directly.
We have an idea to use presaved IRK and mac-addresses and use scanning without witelist...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Overview
In this blog, you will measure the PSM floor current for the rev. 2 version of the nRF9160 SiP.
Requirements
Hardware
You will need:
an nRF9160-DK (the one used here was v1.0.0). Be sure that…
Please note that this blogpost is now deprecated as the nRF52820 is fully supported in nRF5 SDK v17.0.0. We recommend using SDK v17.0.0 for nRF52820 fimware development.
Introduction
The nRF52820 IC is…
This guide is for an older version of the nRF Connect SDK.
For a newer guide on Bootloaders and DFU, we recommend https://academy.nordicsemi.com/courses/nrf-connect-sdk…
Does your build fail today, even though it worked fine yesterday? Are you able to build your project on another computer, but not the one you need to use now? Here are eight things you can try to fix these…
Objectives
Learn to add and configure an I2C/TWI Master Zephyr driver to an NRF Connect SDK project.
Learn to add and configure an I2C/TWI Slave nRFX driver to an NRF Connect SDK project.
Demonstrate…
Using the nRF Connect SDK / West to Program the Radio_Test example into the nRF5340 DK
Background:
There is a need to be able to put a Nordic Semiconductors System-on-Chip / transceiver into modes where…
The "Concurrent Multiprotocol Timeslot API" was introduced with v7.0 of the S110 SoftDevice in 2014. The original purpose was to allow customers to build their own proprietary networks using…