Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Custom Board Uart Communication 0

Hi, I am working on custom board with nrf9160. I want to use LTE LINK MONITOR but my uart don't work. I create simple helloworld application from samples. I change uart0 rx...
- development
- software
- nRF9160
- configuration
- softdevice
- Other
- product
724 views

0 replies

Started over 3 years ago
by Mmterkc
Not Answered
Adding second element to a server node? 0

I'm trying to add a second element to (light_switch\server) (SDK_for_Mesh_v5.0.0). I've already have a look at this post , it gives an idea but I found that it's not applicable...
763 views

0 replies

Started over 3 years ago
by Abdelaziz
Not Answered
nRF52840 DK (PCA10056) at 1.8V VEXT: Interface MCU sporadically resetting 0

Hi, Again the topic which has already been discussed several times in this forum. I just want to share my experience and perhaps help other users having difficulties. ...
845 views

0 replies

Started over 3 years ago
by Norbert
Not Answered
deleted 0

deleted
577 views

0 replies

Started over 3 years ago
by Gopal Kumar
Not Answered
Reduced ESB Receive when running simultaneously with SPIS 0

EDIT: We found the reason for this and it is a hardware issue. This question can be deleted as it is no longer valid. ----- Hello, We are currently developing a...
642 views

0 replies

Started over 3 years ago
by m.li

Recent in Nordic blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015