Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

Which mode can use to set up a dynamic network? 0

Hi, Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...

654 views

0 replies

Started over 11 years ago
by mahone
Not Answered

nRF24AP2 Rx behaviour 0

Dir Sir. I am checking the current profile of nRF24AP2 in RX mode. After "open channel" command, I found the peak current at 10ms interval until connection pass. How does...

835 views

0 replies

Started over 11 years ago
by kazuo KATO
Not Answered

Logging UART data on a PC 0

Hello, I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop. I have two questions: ...

1354 views

0 replies

Started over 11 years ago
by Aditya Bansal
Not Answered
Which priority does softdevice set for SWI2_IRQn 0

SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them? Does sd_nvic_critical_region_enter() disable...
- interrupts
1307 views

0 replies

Started over 11 years ago
by cnshibo
Not Answered
What is the way to have a simple BLE chip work? 0

I am a started guy. I only need a bluetooth device (BLE) to check the signal and mac address. What is the best choice? I need the smallest and low powered! Thank you...
- power
- address
934 views

0 replies

Started over 11 years ago
by Pedro Lopes

Recent in Nordic blog

nRF51 production: program whole flash with one image and start with app mode

Jun Qing ZOU

Recently, there are a few queries from Japanese customers on nRF51 production. Basically the expectations are - Program the flash as a whole, including bootloader, application and soft device - Target…
- 17 Jul 2015
Creating zip package for DFU

Øyvind Karlsen

Introduction This blog will aim to give you an understanding of the zip package required to perform a Device Firmware Upgrade of your device. This blog will apply to the newest tools available to do this…
- 16 Jul 2015
A simple example of using PWM with softdevice S110 using the Nordic nRF51-DK

Mahesh Venkitachalam

A simple example of using PWM with softdevice S110 using the Nordic nRF51-DK. I have tried to remove all unnecessary layers (like the Nordic BSP support) to make this example simple to understand. http…
- 13 Jul 2015
Conferences Plus - IoT Contest winner

tomchy

What, How and Why? The aim of this project was to create the system facilitating the management of big conferences. The first step was to think what a potential end user would like to achieve by…
- 9 Jul 2015
IoT Contest - Mini-Weather Station - Project

buleks

The role of this device is remote measurement environment parameters. It could be accessed anywhere where access to the internet is possible. It uses 6LoWPAN because it's modern IoT technology and have…
- 9 Jul 2015
External nRF51822 SWD Programming using the nRF51-DK

Mahesh Venkitachalam

I've written up a note on programming external nRF51822 boards (like the RedBearLab Nano) using the SWD interface of the nRF51-DK. http://electronut.in/nrf51-dk-external-programming/
- 9 Jul 2015