Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

Do I have to use external host MCU for 51422? 0

Do I have to use external host MCU for nRF51422? What can the ARM Cortex processor inside SoC 51422 do and cannot do? I want to create a mesh network with hundreds of ANT...

1049 views

0 replies

Started over 11 years ago
by johnzhel
Not Answered

S110 7.0.0 : Can I write my own MBR? 0

Hi I am looking at section 9.1 of the S110 Softdevice Specification v1.3A and the release notes for 7.0.0-2.alpha where I see that an application now starts at 0x15000...

1594 views

0 replies

Started over 11 years ago
by Mahendra Tailor
Not Answered

S110 v7.0.0-2.alpha and sd_softdevice_forward_to_application() 0

Hi S110 v7.0.0-2.alpha got released today. In the release notes it says... [b]The SoftDevice can now be configured to forward interrupts to one of several applications...

907 views

0 replies

Started over 11 years ago
by Mahendra Tailor
Not Answered

bulk/block data transfer 0

Does your new implemenation of BLE 4.1 support bulk/block data transfer? What data rate could be possible ? /Best Regards Kjell Bystedt

898 views

0 replies

Started over 11 years ago
by kjell bystedt
Not Answered

Where to get the matching configuration and how to measure the current on every status? 0

Hi, I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...

637 views

0 replies

Started over 11 years ago
by mahone

Recent in Nordic blog

Multiple channels in RTT

Krzysztof Zaraska

Segger RTT (Real-Time Terminal) supports multiple data channels. RTT Viewer uses channel 0 only, and implements multiple virtual terminals on top of this. The terminal can be switched by SEGGER_RTT_SetTerminal…
- 29 Sep 2017
6 Things to Know about Bluetooth Beacons

Rose Martin

Smartphones and tablets have revolutionized the manner in which people communicate with each other. Mobile applications with location-based features like Bluetooth beacons, WiFi, and GPS are helping people…
- 22 Sep 2017
Creating a Keil project for a Bluetooth Mesh example (Updated for 0.10.0)

Kristian Skordal

Introduction The recently released nRF5 SDK for Bluetooth Mesh does not provide Keil project files for its example projects. Fortunately, it's relatively easy to set up your own project from scratch.…
- 19 Sep 2017
Using millis() like in Arduino.

schef

Here are two simple functions to use when you want to use timestamps for time measurement. uint32_t millis(void) { return(app_timer_cnt_get() / 32.768); } and for comperison of current with given…
- 18 Sep 2017
Flashing nRF5x firmware using any dumb terminal program via standard serial COM port

Nguyen Hoan Hoang

There are times that we needed to flash the nRF5x series on a PC where the development software were not installed. The problem could be worst when network access is limited. With a HEX file on hand…
- 18 Sep 2017
How to Debug the nRF52 Interrupts — Useful Tips

Yaniv Nis

Debugging interrupts in not an easy task. During the development of Jumper's Emulator, we gather few useful tips that we think can help you all when debugging the nRF52 interrupts. Hope it will help…
- 13 Sep 2017