Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Custom Board Uart Communication 0

Hi, I am working on custom board with nrf9160. I want to use LTE LINK MONITOR but my uart don't work. I create simple helloworld application from samples. I change uart0 rx...
- development
- software
- nRF9160
- configuration
- softdevice
- Other
- product
723 views

0 replies

Started over 3 years ago
by Mmterkc
Not Answered
Adding second element to a server node? 0

I'm trying to add a second element to (light_switch\server) (SDK_for_Mesh_v5.0.0). I've already have a look at this post , it gives an idea but I found that it's not applicable...
762 views

0 replies

Started over 3 years ago
by Abdelaziz
Not Answered
nRF52840 DK (PCA10056) at 1.8V VEXT: Interface MCU sporadically resetting 0

Hi, Again the topic which has already been discussed several times in this forum. I just want to share my experience and perhaps help other users having difficulties. ...
844 views

0 replies

Started over 3 years ago
by Norbert
Not Answered
deleted 0

deleted
576 views

0 replies

Started over 3 years ago
by Gopal Kumar
Not Answered
Reduced ESB Receive when running simultaneously with SPIS 0

EDIT: We found the reason for this and it is a hardware issue. This question can be deleted as it is no longer valid. ----- Hello, We are currently developing a...
641 views

0 replies

Started over 3 years ago
by m.li

Recent in Nordic blog

nRF52 Range Extension with RFaxis' RFX2411N

Floyd Ashbaugh

External Power Amplifiers and LNAs easily connected to the nRF52 series device for high power extended range operation. Data sheets, white papers, schematics and layout information available at link t…
- 26 Jan 2016
Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016