I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Bluetooth LE is not a fast wireless protocol, transfer speeds are usually measured in single-digit to low tens of kilobytes per second. This is generally not an issue unless large amounts of data need…
PCB Design
Abstract:
The SkyenLab Bluetooth module was developed using the nrf51422 QFN48 QFAC reference design as well as help from the Nordic Semiconductor support portal and white papers. A proof…
Our Project
This post is to clarify team SkyenLab’s scope for satisfying the senior design class requirements and Nordic Semiconductor requirements during the first semester (Aug. 2015 - Dec. 2015) of…
nRF51 Low power modes and power profiles documentation
The low power modes for the nRF51 series are System On and System Off. You can read about them in the nRF51 Series Reference Manual v3.0 sections…
###Note: This tutorial is for the legacy DFU module included in SDK version 11 and earlier. To get started with the new DFU included in SDK 12 and above, please see the SDK documentation in the Infocenter…
Before we begin
Table of context
Before we begin
The "Hello world" example
Advertising
RSSI
Addresses
Address types
Advertising types
Bonding
Advertising data
Scan response data
Change Log 2018…