Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Bluetooth low energy (Re-connection with tags ) 0

please go through the images for better understanding of the problem (as in sequence of 1-5):- any kind of help would be appreciated....
1040 views

0 replies

Started over 11 years ago
by sarang
Not Answered

Interfacing LCD display with nrf51822 evaluation board 0

Hi, I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...

2769 views

0 replies

Started over 11 years ago
by balaji
Not Answered

nRF905 timing requirements when auto-retransmitting. 0

Hi, We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...

776 views

0 replies

Started over 11 years ago
by Ole Christian Tvedt
Not Answered

Running Nordic BLE code in Visual Studio Project 0

This is not a real question for support. It's more a success story i'd like to share with you! Our company develops firmware for various customers on a lot of different...

3924 views

0 replies

Started over 11 years ago
by Adrian Eggenberger
Not Answered

Maximum data rate for the nRF24AP2 when using the Synchronous serial interface 0

Hi all, What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface? I cann't see it in the datasheet. Is there anyone can answer me...

925 views

0 replies

Started over 11 years ago
by Alice

Recent in Nordic blog

Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015

Latest guides

Bluetooth low energy: Bluetooth low energy Advertising, a beginner's tutorial

MartinBL

Before we begin Table of context Before we begin The "Hello world" example Advertising RSSI Addresses Address types Advertising types Bonding Advertising data Scan response data Change Log 2018…
- 31 Mar 2015