Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

Wake-up Times ? 0

Hi, how long does it take time if i would wake up a nrf51422 rev2 (ANT and BLE) in deepest possible sleep mode ? And how long does it tai if after wakeup it had to communicate...

1198 views

0 replies

Started over 11 years ago
by Nils Minor
Not Answered

What does the SWI0 do and how is it used in app_timer? 0

I saw that the app_timer uses the SWI0. Could you explain what it does and what the advantage is compared to "timer_list_handler_sched()" calling "timer_list_handler()" directly...

1064 views

0 replies

Started over 11 years ago
by Mike
Not Answered

Connect to nRF6310 0

Hi, I used the sample code "Master Emulator->2.1.7.8226->Example code->nRFUart" to develop a new project, and encounter some questions... we update nRF6310...

811 views

0 replies

Started over 11 years ago
by Kadi Chang
Not Answered
RX/TX buffers in S110 0

Hello, How many RX buffers are in S110 SoftDevice? I know there are 6 TX buffers (so you can send 6 packets per Connection Interval). How is it on receiving? Is it e...
- s110
- nrf51822
1219 views

0 replies

Started over 11 years ago
by Cyril Hruscak
Not Answered

How can I ensure not be Interrupted by radio when I use gpio simulate IIC? 0

My sensor is off-standard,so I have to use gpio to read and write my sensor. Gpio IIC will take about 0.5ms to get data. My app need send data every 7.5ms,it seems that...

822 views

0 replies

Started over 11 years ago
by gootoomoon

Recent in Nordic blog

Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015