Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Behavior of nRF54L15 During Supply Voltage Transients 0

According to the nRF52832 Product Specification, “A step increase in supply voltage of 300 mV or more, with rise time of 300 ms or less, within the valid supply range, may...
25 views

0 replies

Started 7 hours ago
by bdub94
Not Answered
Request: Thingy-91x support in DevAcademy Intermediate Exercise 3 – DFU with external flash 0

https://academy.nordicsemi.com/courses/nrf-connect-sdk-intermediate/lessons/lesson-9-bootloaders-and-dfu-fota/topic/exercise-3-dfu-with-external-flash/ I have this exercise...
39 views

0 replies

Started 7 hours ago
by sd30
Not Answered
nRF54L NRESET pin reference design termination 0

Hi, I noticed in the nRF54L QFN48 reference design, for the NRESET pin, there is an RC filter (1Kohm series R and 3.9pF shunt cap). What's this for and is it necessary?...
25 views

0 replies

Started 9 hours ago
by jlegstrong
Not Answered
SPI pins are outputting low voltages (100mV amplitude) 0

Hello, I am using a nrf5340 dev kit. When I use SPIM the output from the pins gives the correct hex values but the output's amplitude is only around 100-200 mV. I know that...
- development
- spi
- hardware
- nRF5340
22 views

0 replies

Started 9 hours ago
by LeeHagrid
Not Answered
What could the nRF52840 be doing while apparently idle — and what are the risks of interrupting it with a reset? 0

Hi, I'm using the nRF52840 with the SoftDevice for BLE. In my system, it's primarily a BLE transceiver controlled via SPI by an external TI MSP430. We're considering implementing...
43 views

0 replies

Started 10 hours ago
by coiti4

Recent in Nordic blog

Bluetooth mesh and its role in the Internet of Things

Mohammad Afaneh

If you ask five different people “How would you define the Internet of Things?”, you will probably get five different answers! The term has generated a lot of buzz in the media in the past few years. You…
- 16 Oct 2019
nRF9160 Pathfinder

Marte Myrvold

The nRF9160 SiP supports the use of both LTE-M and GPS. We want to show how these can be used in an application at the same time. In this project we demonstrate this by using the nRF9160 DK to send the…
- 7 Oct 2019
Q&A for "Introduction to nRF Connect SDK" webinar

Petter Myhre

This blog post contains answers to questions asked during the "Introduction to nRF Connect SDK" webinar hosted by Nordic Semiconductor 25.09.2019. You can watch a recording of the webinar her…
- 7 Oct 2019
nRF Connect for iOS: What is a Bug-fix Release?

Dinesh Harjani

It's been a month since we last spoke, when we announced the release of nRF Connect for iOS 2.0. What a day that was, wasn’t it? In any case, we’re here because, since then, we’ve made three successive…
- 30 Sep 2019
Summer challenge: the 1000m long Zigbee link.

tomchy

There are smart home applications that require an extended radio range. Is it possible to use Zigbee/BLE multiprotocol solution to increase the Zigbee mesh network coverage?
- 6 Sep 2019
Q&A for "Introduction to Nordic Thingy:91" webinar

Petter Myhre

This blog post contains answers to questions asked during the "Introduction to Nordic Thingy:91" webinar hosted by Nordic Semiconductor 22.08.2019. You can watch a recording of the webinar h…
- 2 Sep 2019