Hello! We are in the middle of an upgrade to 3.2.1, and we encounter the following issue using SB_CONFIG_MCUBOOT_MODE_SWAP_WITHOUT_SCRATCH, SB_CONFIG_MCUBOOT_MODE_SWAP_USING_MOVE...
Hi everyone,
I'm using the nRF5340 on a custom PCB board without an external 32 kHz oscillator. On the network core I flashed the hci_ipc sample.
For some reason I occasionally...
Hello,
I am measuring RSSI values with nrf_modem_dect_phy_rssi(...) from the DECT PHY firmware.
The nrf_modem_dect_phy_rssi_event refers to positive values being saturated...
Hi all,
I'm working on BLE time synchronization between nodes using hardware timestamps via GRTC + DPPI + PPIB cross-domain. CRCOK and PHYEND work perfectly, but adding...
It seems there might be a small issue with the TF-M GPIO MCU-select IOCTL plumbing on nRF54L — specifically when a non-secure app tries to configure sQSPI GPIOs (and presumably...
The Cannybot Brain is a robotics controller board that uses the Nordic Semiconductor nRF51822 at its core. The board has been developed by Cannybots Limited in Cambridge, UK.
One of Cannybots core values…
In corporation with Nordic Semiconductor we are happy to announce our programming services!
Your flexible programming center is based in Gothenburg, Sweden at HI-LO Electronics AB
Advantages with pre…
Over the last few months we have been working on a new desktop application for Bluetooth Smart devices which will give you easy access to the most common Bluetooth features and allows you to control locally…
Ever wondered how the nRF51822-based BBC Micro:bit first started to come to life?....Then read on....
Working with the BBC on micro:bit: Part 1 - using the mbed HDK
For the last few months, we’ve been…
It’s that time again
The Nordic Global Tech Tour is about to hit the road again. This time it is all about the goodies inside our nRF52 Series for Bluetooth Smart and what they enable you to do.
The…
Since I couldn't find the information of how the supply current would change with different supply voltage for nrf51 chip, this is the result of a little test that I made to get this info.
Setup: nrf51…