Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
I2C devices are not getting detected in NRF54L15 Dev Kit. 0

I am unable to detect any i2c device when connected to the Nordic nRF54L15 DK kit. I have change the voltage from 1.8v to 3.3v and Tried and explore other pins in Port 0 and...
- software
- beginner
- nRF Connect SDK
- debugging
- nRF54L05
- Evaluation
- Protocol
- nRF54L15
- documentation
- zephyr
- twi
21 views

0 replies

Started 8 hours ago
by rsramki
Not Answered
Nrf54l05 bt connection crash 0

HI: D:\ncs\v3.0.0\nrf\samples\bluetooth\peripheral_uart Using the nrf54l15DK board can run peripheral_uart examples,connection is disconnected. However, when I use the nrf54l05...
13 views

0 replies

Started 8 hours ago
by john.liu
Not Answered
NRF54L15 wedging when starting BLE advertising, peripheral_uart sample 0

Hi, I'm working on software for a design incorporating an Ezurio module that uses an NRF54L15 chip. I'm currently using the peripheral_uart example as a base for early...
22 views

0 replies

Started 9 hours ago
by Peter Davis
Not Answered
nrf connect sdk on nrf9161 using GPIOTE fails to build 0

I want to use gpiote and functions like: - nrfx_gpiote_input_configure - nrfx_gpiote_in_event_enable This is added to the top of my document: #include <nrfx_gpiote...
14 views

0 replies

Started 10 hours ago
by Mart
Not Answered
nRF7002 antenna matching circuit 0

Dear Nordic, This post is successor of https://devzone.nordicsemi.com/f/nordic-q-a/122755/nrf7002-rfbuck-vdd-voltage as continuous of the work. Although there are still...
- development
- antenna
- rf design
- hardware
- nRF7002
20 views

0 replies

Started 11 hours ago
by rolandash

Recent in Nordic blog

Nordic Semiconductor nRF51822 Firmware for Background Data Recording

scytulip

#Nordic Semiconductor nRF51822 Firmware for Background Data Recording Updating on https://github.com/scytulip/nrf51-back-rec Design Objective This firmware is designed for low-cost long-time low-power…
- 23 Oct 2014
Nordic nRF51822 ARM Cortex-M0 Development using emIDE

Hugh

Nordic nRF51822 ARM Cortex-M0 Development using emIDE To avoid the hefty charges with commercial compilers I tried emIDE with some success; here are the settings I used for the EV Kit Official emIDE…
- 22 Oct 2014
Beacon Kit - Mistake in Ref_Design_UG_v1.0

Salman

I connected the programming header as described in "nRF6930_Beacon_Ref_Design_UG_v1.0.pdf" 5.5.4 Programming interface. I was trying to program Beacon Kit but failed many times then I compared it with…
- 10 Oct 2014
SD card interfacing

Salman

Hi, I have written SD & SDHC card routine for reading, writing and erasing data from SD card. It used the hardware SPI of nRF51822. NOTE: 1)Define the PINs of SD card first before initialing. 2)Define…
- 10 Oct 2014
How different BLE packet types influence throughput

Stefan Birnir Sverrisson

There are several types of write operations, write request with authorization, write request without authorization and write command. You can see message sequence charts for those messages here and he…
- 9 Oct 2014
Measuring Lithium battery voltage with nRF51

Stefan Birnir Sverrisson

Here is an example of a hardware setup to measure the voltage on a Lithium battery with a voltage divider and a connected capacitor. The Lithium battery typically has a voltage range of 2.7 - 4.2 V and…
- 2 Oct 2014