Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF54L15 reduce build time 0

Hi, I assume this would apply to most new boards - but I am finding that the build time since upgrading to newer hardware has increased significantly. Perhaps due to sysbuild...
- development
- software
- flash
- nRF54L15
- configuration
- zephyr
25 views

0 replies

Started 6 hours ago
by Ryan S
Not Answered
NRF52832 high idle power consumption 0

I am currently using ncs 2.9.0 on a custom board using the internal ldo and internal clock settings. It is a simple project where I take and indicate an adc and internal temperature...
14 views

0 replies

Started 7 hours ago
by roavmf
Not Answered
Using GRTC to output the LFCLK via GPIO (sourced from an external 32.768 kHz crystal) 0

Hi! I am designing a nRF54 based motion tracker that has an IMU onboard which can take an external clock signal for improved timing accuracy. Initially I had thought of just...
22 views

0 replies

Started 7 hours ago
by SimbiJohnson
Not Answered
Custom board crashes calling bt_enable 0

Hello I have a custom board with the following dts My zephyr app crashes in bt_enable() Note that uart0 TX pin 8 is used by gps_vrtc_en but uart0 is not defined. Same crash...
16 views

0 replies

Started 7 hours ago
by AndyM
Not Answered
Build failed using Toolchain v3.0.2 and sdks v3.0.2 0

Dear All, I updated Toolchain and SDKs to last version v3.0.2 and I'm going to add build configuration as suggested here How to create and build an application . My board...
12 views

0 replies

Started 8 hours ago
by MPDeveloper89

Recent in Nordic blog

LTE-M vs NB-IoT Field Test: How Distance Affects Power Consumption

Martin Lesund

This is an updated field test of the one we did in 2019 at the same location. During this updated field test, we also captured more parameters for both LTE-M and NB-IoT devices and, we captured power measurements…
- 8 Sep 2022
On nRF Connect for the Mac, the new nRF Edge Impulse and the Discovery of SwiftUI

Dinesh Harjani

Preface The bulk of the development work described in this blog post occurred during the 2021 calendar year. This means it reflects the state of iOS, Mac, Swift, and SwiftUI Development before and after…
- 1 Sep 2022
Traveling the embedded world 2022

Finn Boetius

The embedded world trade fair presents itself as the leading trade fair for embedded systems. It allows the embedded community to get information about new products and innovations. But also allows us…
- 3 Aug 2022
Developing and testing Bluetooth Low Energy products on nRF52840 in Renode and Zephyr

Michael Gielda

The Bluetooth Low Energy (LE) connectivity standard has gained immense popularity in recent years, mainly due to the growing ubiquity of IoT solutions in both consumer electronics and industry. Thanks…
- 4 Jul 2022
Machine Learning with the Thingy:53

Øyvind

The Thingy:53 is our newest prototyping platform based on the nRF5340 SoC and it comes preprogrammed with firmware developed by Edge Impulse. This firmware supports all Edge Impulse features, including…
- 28 Jun 2022
LE Audio through a technical lens

Karl Ylvisaker

The highly anticipated nRF5340 Audio Development Kit and nRF Connect SDK software module is finally available. On that occasion, I am writing this blog post to quickly get everyone up to speed on the most…
- 20 May 2022