Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
How to read cluster attribute values for on/Off cluster in Zigbee Network Coordinator 0

Hi What is the best way to read cluster attributes periodically in zigbee network coordnicator? any sample code available for one time request or subscription for value change...
- development
- software
- nRF Connect SDK
- zigbee
- zephyr
- nrf52840
0 views

0 replies

Started 7 hours ago
by Dhaval Dalvadi
Not Answered
NCS 2.8.0: path length problem during build under Windows 0

Hello, I know that this issue comes up from time to time. I'm raising it again, because to my opinion there have to be a solution for this. Perhaps there is, that's the...
0 views

0 replies

Started 8 hours ago
by rgrr2
Not Answered
Pin configurations for GPIO pins on NINA-B306-00B nRF52840 BLE module 0

Hello I’m using the NINA-B306-00B BLE module which uses the nRF52840 MCU for a custom board application. The BLE module interacts with two sensors, an accelerometer via SPI...
9 views

0 replies

Started 9 hours ago
by neeld
Not Answered
Correct way to integrate MQTT wifi sample into an existing project? 0

Hi, SDK: nRF Connect v2.7.0. Hardware: nrf5340 + nrf7002 module ( WT02C40C ) on a custom board. IDE: Visual Studio Code 1.95.3 (obviously with the nRF Connect extension...
11 views

0 replies

Started 10 hours ago
by __RICHARD__
Not Answered
Confirmation of nRF5340 CC312 Accelerator Usage and Power Consumption Analysis 0

1. When adding CONFIG_PSA_CRYPTO_DRIVER_CC3XX=y to the configuration as shown in the diagram, does it enable the use of the CC310 accelerator? 2. My understanding is...
21 views

0 replies

Started 13 hours ago
by giun.kim

Recent in Nordic blog

New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018

Latest guides

Bluetooth low energy: Bluetooth low energy Services, a beginner's tutorial

MartinBL

Before we begin Scope Topics that will be covered include: Before we begin Necessary equipment and software Necessary prior knowledge Some basic theory The Generic Attribute Profile (GATT) Services…
- 26 Aug 2015
Software Development Kit: Setting up the Timeslot API

Hung Bui

Setting up the Timeslot API When you want to use the radio while still maintaining a BLE connection or have a task that you need to do uninterrupted by radio activity, you can set up a timeslot. The timeslot…
- 27 Jul 2015
Software Development Kit: Radio Notification

Øyvind Karlsen

Radio Notification In this tutorial we will set up a beacon example and modify it to use radio notification. Then we will use radio notification to light a LED when the radio is transmitting. While this…
- 17 Jun 2015
Software Development Kit: Board support package (BSP)

Øyvind Karlsen

Board Support Package In this tutorial we will use the Board Support Package to control hardware peripherals on the nRF51 or nRF52 DK. Required tools Keil 5.20 nRF SDK 11 nRFgo Studio 1.21.…
- 8 Jun 2015
nRF5x: nRF51 series current consumption guide

Stefan Birnir Sverrisson

nRF51 Low power modes and power profiles documentation The low power modes for the nRF51 series are System On and System Off. You can read about them in the nRF51 Series Reference Manual v3.0 sections…
- 1 Jun 2015
Software Development Kit: Setting up device firmware update(DFU) on the nRF5 DK

Stian Røed Hafskjold

###Note: This tutorial is for the legacy DFU module included in SDK version 11 and earlier. To get started with the new DFU included in SDK 12 and above, please see the SDK documentation in the Infocenter…
- 1 Jun 2015