Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
After using Android nRF Connect FOTA, why the settings storage partition of my device was erased? 0

hi everyone After using Android nRF Connect FOTA, the settings storage partition of my device was erased, which means that my device's PAIR information was lost and the...
14 views

0 replies

Started 13 hours ago
by Liuguofeng
Not Answered
nRF54H20: UICR->OTP for Serial Number Storage - Factory Programming 0

Hi Nordic Team, I'm looking to use the UICR->OTP region ( One Time Programmable (OTP) memory region within the User Information Configuration Registers (UICR)) on the nRF54H20...
38 views

0 replies

Started 16 hours ago
by lammobile
Not Answered
I have problem when i use nRF52840 to make a touchpad 0

Hello, I have made a PCB has 4 buttons and touchpad, now I want to drive all of them. 1. one button for left button of mouse. 2. one button for right button of mouse....
- development
- software
- C
- bluetooth le
- nrf52840
21 views

0 replies

Started 18 hours ago
by Harvey.Zhang
Not Answered
Is it possible to mount a LittleFS partition in RAM only, in order to extend the product's lifespan with respect to flash erase/write limitations? 0

Hello I'm currently mounting a LittleFS partition in the internal flash of my Nordic MCU. However, since data is saved regularly to this partition, I’m concerned that the...
38 views

0 replies

Started 1 day ago
by Aurele
Not Answered
Using mcuboot_status_change() to control GPIO and I2C during MCUboot execution 0

Hi! I’m currently implementing a hook using mcuboot_status_change() inside MCUboot. I’m following the path defined by CONFIG_MCUBOOT_ACTION_HOOKS , and I’ve confirmed that...
29 views

0 replies

Started 1 day ago
by Agustin Perez

Recent in Nordic blog

Fast Production Screening based upon Bluetooth DTM

Ken L

The challenge As a product is getting into the production phase, the need of a fast and standalone screening facility on the production line arises. Here I'm introducing a production screening setup…
- 9 Dec 2016
I am developing an open source sensor beacon board

zelin

I am developing an open source sensor beacon board named: YS-Beacon which contains: nRF52832 DAPLink - LPC11U35 9-Axis Motion Sensor Ambient Light Sensor、Proximity Sensor and 3D-Gesture Sensor with…
- 2 Dec 2016
nRF52 Rocket: Part I – Introduction to Model Rocketry and its UX Problem

Tony Wu

Official Launch Video Welcome to this 2 or 3-part blog about the nRF52 Rocket, a BLE-enabled model rocket, which you’ve just seen soaring through the air in the video above. In the first part of blog…
- 21 Nov 2016
What to keep in mind when developing your BLE Android app

Hung Bui

BLE is native supported on Android from v4.3. It has been continuously improved as Android evolving. It's getting more and more complex with additional features. It's important that a Bluetooth app should…
- 14 Nov 2016
Get started on PC Software for Mesh and Mesh DFU

David Edwin

nRF-connect-Mesh PC tool allows the user to demonstrate the nRF OpenMesh and the Mesh Device Firmware Update (DFU). The Mesh DFU will be used for nRF OpenMesh and the Bluetooth Mesh when it is made available…
- 11 Nov 2016
The Power Profiler Kit

wlgrd

Many developers might be familiar with the problems that may arise when wanting to measure current consumption, especially with applications using from a couple of µA to some mA. You most probably have…
- 3 Nov 2016