Hi
Followup on this ticket: Enabling SPI and TWI drivers on Zephyr
First the fundamentals, I am using:
nRF52840-DK
nRF Connect for VS Code: v2024.7.13
nRF...
Hi,
We are working on power optimization for our project using the nRF5340 board. Our code implements an RTOS, BLE for data transfer, I2C and SPI for device communication...
Hello,
I am purchasing a RAK4631 module, and am looking for an alternative for the J-link single step debugger. I saw that this product had a o n-board SEGGER J-Link debugger...
Hello.
I encountered the following problem. I have an nRF52840 microcontroller that is already soldered onto the PCB board. It doesn't have any bootloader. As an example...
Hi there
During updating nRF5340 over bluetooth, really rarely the CPUNet fails to be updated over bluetooth.
The mcuboot says: Image in the secondary slot is not valid...
Overview
In this blog, you will measure the PSM floor current for the rev. 2 version of the nRF9160 SiP.
Requirements
Hardware
You will need:
an nRF9160-DK (the one used here was v1.0.0). Be sure that…
Please note that this blogpost is now deprecated as the nRF52820 is fully supported in nRF5 SDK v17.0.0. We recommend using SDK v17.0.0 for nRF52820 fimware development.
Introduction
The nRF52820 IC is…
Purpose
The purpose of this blog is to showcase how a single USB bus can be used as the physical transport for multiple protocols when an external CPU is the controller.
Specifications as tested
Boards…
Table of Contents
Objectives
What are device tree overlays, and how do they relate to shields?
Why are Arduino nodes not recognized in the nRF9160 DK?
The workaround: Using the shield as a board ove…
Table of Contents
Hardware
Components
Wiring
Software
Prerequisites
Steps
Incorporating this into other projects
Further reading
Attached files
This blog post demonstrates how to get a LVGL sample…
Background:
There is a need to be able to put a Nordic Semiconductors S0C /transceivers into modes where the physical layer and RF characteristics may be ascertained. The radio test example is used to…
This is part 2 of the series Building a Bluetooth application on nRF Connect SDK - Contrasting to SoftDevice based Bluetooth applications
You can find the other parts here:
Part 1 - Peripheral Role.
Part…
Objectives
Provide a brief primer to NCS and Zephyr
Provide a quick-start guide to adding peripherals to an existing sample project
Demonstrate running both foreground and background tasks within Zephyr…