Description : It is not possible to flash or debug an application with IAR on the Nordic target. This issue is caused by a bad interaction between CMSIS-DAP IF present on...
Hi,
What should i do after i load mesh app in " github.com/.../nRF51-ble-bcast-mesh" adress?i have two board
When i download the app,why doesnt advertising exist.i cant...
hello
i am using the Nrf52dk with Visualgdb.
i try to run the example project (tcp/IP -> client).
i am using the Nrf5 IoT sdk v0.9
Project complied successfully but i...
The ultra simple to use pxt editor for Microbit (https://pxt.microbit.org/) supports sending data using the nRF51822 radio. The tool supports using both BLE and proprietary protocols.
For this project…
mROBerTO (milli-ROBot-TOronto) is a small modular millirobot designed and implemented for swarm robotics research. It was first featured in the 2016 IEEE/RSJ International Conference on Intelligent Robots…
In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product:
Device State
Device Configuration
Past Data
Firmware Updates
It's these …
Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
Nordic's Power Profiler Kit (PPK) is an inexpensive piece of hardware that can provide a significant amount of insight into the operation and performance of your project. Although there is a lot that…
This project was originally made in an outdated version of NCS, but it has now been updated to NCS v1.5.0. The instructions are the same as before, but the code is different.
Disclaimer: This is a student…
Purpose
This document will show how to automate the provisioning process for Nordic BLE Mesh nodes using Python scripting. When provisioning nodes using PyACI (Python Application Controller Interface)…
I implemented parts of the BLE-MIDI service along with a small example application. I wanted to share it here on the blog, in case someone would find it useful. The intended audience is primarily someone…