Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

I am trying to write the bsp for nordic nRF51. I added the device information service and i want to change the system id of the DIS (dis_init.p_sys_id) without success . Can you please tell me how can i do it. Thank you. 0

dis_init.p_sys_id->manufacturer_id = 0x5555; dis_init.p_sys_id->organizationally_unique_id = 0x5555; This is not change anything.

565 views

0 replies

Started over 8 years ago
by Anna
Not Answered

Looking for developer in Minnesota, N. Dakota, S.Dakota 0

Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...

545 views

0 replies

Started over 8 years ago
by tdors
Not Answered

nRF52 EasyDMA must be on all the time? +1

I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...

1366 views

0 replies

Started over 8 years ago
by Yano
Not Answered
Multiple nrf51288 uart connection 0

Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 . idea similar to this: ...
- nrf51822 mbed
1393 views

0 replies

Started over 8 years ago
by titusf
Not Answered
SPI: Cannot write to full LCD screen 0

Hi, I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI. Currently the code writes two numbers and a...
- nrf51422
- nrf51
762 views

0 replies

Started over 8 years ago
by LK13131

Recent in Nordic blog

Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015
ROM and RAM Management

Øyvind Karlsen

Introduction Here are some tips and tricks to manage your application size. RAM and ROM usage The total RAM usage is: ZI-data + RW-data The total flash usage is: Code + RO-data + RW-data …
- 28 Jul 2015