Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

I am trying to write the bsp for nordic nRF51. I added the device information service and i want to change the system id of the DIS (dis_init.p_sys_id) without success . Can you please tell me how can i do it. Thank you. 0

dis_init.p_sys_id->manufacturer_id = 0x5555; dis_init.p_sys_id->organizationally_unique_id = 0x5555; This is not change anything.

547 views

0 replies

Started over 8 years ago
by Anna
Not Answered

Looking for developer in Minnesota, N. Dakota, S.Dakota 0

Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...

519 views

0 replies

Started over 8 years ago
by tdors
Not Answered

nRF52 EasyDMA must be on all the time? +1

I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...

1334 views

0 replies

Started over 8 years ago
by Yano
Not Answered
Multiple nrf51288 uart connection 0

Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 . idea similar to this: ...
- nrf51822 mbed
1355 views

0 replies

Started over 8 years ago
by titusf
Not Answered
SPI: Cannot write to full LCD screen 0

Hi, I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI. Currently the code writes two numbers and a...
- nrf51422
- nrf51
730 views

0 replies

Started over 8 years ago
by LK13131

Recent in Nordic blog

Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016

Latest guides

Bluetooth low energy: Bluetooth low energy Advertising, a beginner's tutorial

MartinBL

Before we begin Table of context Before we begin The "Hello world" example Advertising RSSI Addresses Address types Advertising types Bonding Advertising data Scan response data Change Log 2018…
- 31 Mar 2015