Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Receiver sensitivity 0

We are using nRF51822 for our products. We want to know the min value of "Receiver sensitivity" when we use this chip for BLE. The Datasheet says "Receiver sensitivity...
- receiver sensitivity nrf51822
2263 views

0 replies

Started over 9 years ago
by makoto
Not Answered
How to send and recive data to mutiple peripheral devices 0

Dear The BLE Multi-link example (ble_app_multilink_central and ble_app_multilink_peripheral) shows how one central device can connect to multiple peripheral devices. ...
- multiple peripheral
675 views

0 replies

Started over 9 years ago
by sjkim
Not Answered
Eddystone URL parser is broken in MCP 0

In the MCP app, if I have the following service data for an Eddystone beacon: 0x10, // Eddystone-URL type 0x00, // TX power in dBm. This is a signed integer so 0xEE ...
825 views

0 replies

Started over 9 years ago
by Tim
Not Answered
Cannot connect to BLE devices requiring random LE address type with Android nRF app 0

I have the nRF Control Panel Android application. It works fine with several BLE devices, but specifically for the Fitbit Flex, it fails to connect. I know Fitbit wristbandes...
3045 views

0 replies

Started over 9 years ago
by Axelle
Not Answered

Communication between Gazell and non-gazell devices 0

Hi, The situation: I was able to successfully receive known packets from a device running gzp_device_dynamic_pairing, from, the host running the gzp_host_dynamic_pairing...

794 views

0 replies

Started over 9 years ago
by nordicdev

Recent in Nordic blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015