Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Custom Sensor Driver for CT1711 Temperature Sensor 0

I am trying to create a custom sensor for CT1711 temperature sensor. I have created the sensor driver code and device tree binding, but it won't start (initialize) and the...
- development
- software
- zephyr
- nrf52832
62 views

0 replies

Started 4 days ago
by nanangcreacoll
Not Answered
NRF Cloud Shadow Update / AT Command messaging delay 0

Hi, Is it possible to make the MQTT connected device receive the Shadow config updates and AT Commands immediately? Based from our testing, the device only receives the...
69 views

0 replies

Started 4 days ago
by AdrianT
Not Answered
Regarding I and Q measurements on the nRF54L15 development kits 0

Hi Nordic Support Team, I'm currently experimenting with Channel Sounding using a couple of nRF54L15 boards. I am trying to obtain raw I and Q samples so that I may analyze...
112 views

0 replies

Started 6 days ago
by ignatious-p
Not Answered
Matter + OpenThread + PSA (Oberon): Crypto/Memory Optimization + mbedTLS Logging 0

Hello, currently i am configuring the networking stack on my project. The goal is to use Matter's built-in Thread connection, to establish a Secure CoAP connection. I...
67 views

0 replies

Started 6 days ago
by jlux
Not Answered
Android 15 introduces bug where bonded devices cannot be disconnected 0

We use several Nordic chips in our BLE sensors. We bond to the devices from Android, connect to update configurations, then disconnect such that the device then advertises...
104 views

0 replies

Started 15 days ago
by RickW

Recent in Nordic blog

FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015