I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Bluetooth LE is not a fast wireless protocol, transfer speeds are usually measured in single-digit to low tens of kilobytes per second. This is generally not an issue unless large amounts of data need…
PCB Design
Abstract:
The SkyenLab Bluetooth module was developed using the nrf51422 QFN48 QFAC reference design as well as help from the Nordic Semiconductor support portal and white papers. A proof…
Our Project
This post is to clarify team SkyenLab’s scope for satisfying the senior design class requirements and Nordic Semiconductor requirements during the first semester (Aug. 2015 - Dec. 2015) of…
TL;DR: It ignores whatever the computer tells it to do and does an automatic detection.
And the reason? UART terminals are not doing flow control settings in a consistent way, and in some cases incorrectly…
Introduction
A few months ago I started running again. Music helps me to stay motivated. Since most earphones keep falling out, especially when the sweat comes out, I googled for some sports earphones…
List of changes from µESB to nrf_esb
All functions, structs, enums and defines have been renamed from uesb_xxx to nrf_esb_xxx.
Events:
Events used to be triggered within radio interrupt context…