Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
usb-to-uart firmware and driver 0

I am in need of the usb-to-uart.hex firmware and the driver for it. This is required to test the radio dongle nRF24LU1+ device (32k) whether it can be programmed through USB...
- nrfg0 nrf24lu1p usb interface
889 views

0 replies

Started over 9 years ago
by Raj005
Not Answered
Can not create an SPI connection 0

I've been unsuccessfully trying to serialize BTLE example programs by SPI. I have two PCA10028 boards and I'm using SDK10. In addition to serialization examples, I've tried...
918 views

0 replies

Started over 9 years ago
by J50
Not Answered
IoT SDK - cannot connect to nrf51822 using newer linux kernel 0

Hello, Connection between linux router and NRf51 devices worked before I've updated kernel version from 4.09 to 4.3. Now, with the same configuration and hardware, I'm not...
- bluetooth 6lowpan
- 6lowpan
- debug
- linux
- nrf51822
- kernel
- iot
1265 views

0 replies

Started over 9 years ago
by Michal
Not Answered
IoT SDK - linux can't connect to NRf51 using new kernel 0

Hello, Connection between linux router and NRf51 devices worked before I've updated kernel version from 4.09 to 4.3. Now, with the same configuration and hardware, I'm not...
- router
- iot sdk
- 6lowpan
- nrf51
- 4.3
- linux
- bluetooth_6lowpan
- nrf51822
- kernel
- iot
1136 views

0 replies

Started over 9 years ago
by Michal
Not Answered

CE—compliant nRF24LU1+ module 0

Hi Does anyone know a CE—certified module based on the nRF24LU1+? Ideally, it should have an SMA connector, but any kind of antenna would be fine. There are many modules...

542 views

0 replies

Started over 9 years ago
by Salvador Sancha

Recent in Nordic blog

Comparing compilers/IDEs for development with nRF5x series devices

Michael Dietz

#Introduction All compilers ARE NOT created equal. Given the same c code, different compilers will generate machine code with varying performance & size. Generally the more efficient machine code (uses…
- 28 Jan 2016
nRF52 Range Extension with RFaxis' RFX2411N

Floyd Ashbaugh

External Power Amplifiers and LNAs easily connected to the nRF52 series device for high power extended range operation. Data sheets, white papers, schematics and layout information available at link t…
- 26 Jan 2016
Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016