LPCOMP delay

Question

Hi, 
 I can't find any data on the analog comparator delay in the datasheet. Except the 15 us for anadetect signal. Is this the delay through the comparator for normal signals as well? What would the total delay be through comparator and PPI to a GPIO pin? And what would expected jitter for that delay be? 
 Trying to implement a cheap way of measuring small (< pF) capacitance-changes by using the lpcomp in an rc-relaxation oscillator.

Stefan Birnir Sverrisson · Accepted Answer

Hi 
 The delay though a PPI channel should be one clock cycle, i.e. 62.5ns 
 The delay in LPCOMP from the time an input signal exceeds the configured reference signal with 50mV is typically around 20us until an event is triggered (UP, DOWN or CROSS). If the input signal is more than 50mV higher than the reference, the delay is going to be somewhat smaller. Similarly, if the input signal is less than 50mV higher than the reference, there is more delay. It is perhaps not as deterministic as you would like it to be, but 20us should give you at least an idea. 
 On the other hand, there is a cap-sense example available on Nordic's Github which uses a TIMER, LPCOMP and two GPIO pins to implement cap-sense. Is that what you are thinking about? It implements auto-calibration feature and is fairly efficient on current consumption.