Problem when connecting BLE 4.x device and BLE 5.0 device at same time

[Oliver71]

Need support.

 

I am using lierda S98B module together with Nordic S140 SoftDevice as master. So far everything works fine. I can connect up to 4 devices with BLE 4.2. Also I can connect up to 4 devices with BLE 5.0.

 

But after connecting a BLE 4.x device once no more devices with BLE 5.0 can be connected. If configure BLE_BAS_CONFIG_LOG_LEVEL 4 following debug message can be found:

 

00> <info> app: Start Service Discovery

00> <debug> nrf_ble_gq: Purging request queue with id: 1

00> <debug> nrf_ble_gq: Registering connection handle: 0x0001

00> <debug> ble_db_disc: Starting discovery of service with UUID 0xFFF0 on connection handle 0x1.

00> <debug> nrf_ble_gq: Adding item to the request queue

00> <debug> nrf_ble_gq: GATTC Primary Services Discovery Request

00> <debug> nrf_ble_gq: SD is currently busy. The GATT request procedure will be attempted                       again later.

00> <debug> nrf_ble_gq: Processing the request queue...

00> <debug> nrf_ble_gq: GATTC Primary Service Discovery Request

00> <debug> nrf_ble_gq: SD is currently busy. The GATT request procedure will be attempted                           again later.

00> <debug> nrf_sdh_ble: BLE event: 0x11.

 

Anyone can help ?

[Hieu]

Hi Oliver71,

This is a very strange issue. I don't think anything like this has been reported before.

BLE_BAS_CONFIG_LOG_LEVEL only increases the log level for the BAS module. Could you please increase NRF_LOG_DEFAULT_LEVEL to 4, and also any modules involved in the process of scan, connect, and service discovery?

If you are not sure what modules we should log from, please give me an overview of what modules you are using and how the connection process is setup in your code.

Finally, could you please give an overview of what peripheral devices you are using?

Hieu

[Oliver71]

Hello Hieu,

here more details
We have 2 types of devices. We call them Gen1 and Gen2. Gen1 is with bluetooth 4.x and Gen 2 with bluetooth 5.0

I was in contact with lierda and they used a bluetooth sniffer to get more information.

If connect an Gen1 device first and then connect a Gen2 device the Attribute Handle change from 6 to 12.
I have 2 pictures with screenshots from the sniffer. The pictures seems to be to big to upload into this chat. Can i send the pictures directly to u ?

[Oliver71]

FE63

12 is the handle of FE63

fff1

fff2

the first picture is about connection to g1 probe first and then connect to g2 probe

the second picture is only connection to g2 probe

you can see on the first picture the handle change to 12

so the data write from fff1 to fe63

[Hieu]

It seems the picture was corrupted. Could you please retry?

I am on sick leave now, but I will check it when I return.

[Oliver71]

[Oliver71]

[Hieu]

It seems the pictures are still corrupted 

Maybe the website is not very stable these days. Could you please check that the image can be viewed in Preview first? I am sorry for the inconvenience.

Alternatively, you can also upload the sniffer log and tell me what you would like to highlight.

Sorry, it seems the picture is only corrupted in our Support page. I see the pictures in the public page just fine. I will get to it once I return to office.