Custom Uart baud rate 117600

[Joon Kim]

Hello,

We are using UART channel to communicate with the other MCU, 

It has a specific clock to save power but its only option is 117600 baud rate which corresponds to 2% deviation of 115200.

Is there any way to configure 117600 and make it work?

Thanks

[Hieu]

Hi Joon,

UART baud rate is configured in the BAUDRATE register. You can try to reach 117600 baud rate by tweaking the value slightly up from 0x01D60000, the rated value for 115200 baud rate.

Please note that this will be unofficial and not tested, so we also cannot guarantee you that it would work. If you pursue this option, please perform thorough testing.

Hieu

[Joon Kim]

Hi Hieu,

Thanks for the information, I am going to have to try that way,

For the register value corresponding to 115200 baud rate, your link says it is 0x01D60000 but my sdk s140 shows 0x01D7E000UL in nrf52840_bitfields.h.

I found a post related to this question, it is for nrf52832, here https://devzone.nordicsemi.com/f/nordic-q-a/43280/technical-question-regarding-uart-baud-rate-generator-baudrate-register-offset-0x524 

Do you think this also work for nrf52840 ?

Thanks,

Joon

[Hieu]

Hi Joon,

Good finding. I noticed that one value is for the UART peripheral, and one is for the UARTE peripheral. You will find both value in the same MDK header file, and in the Product Specification.

I am not certain if some difference between the two peripherals is to account for that difference and have started an internal query about it. I will update you when I receive an answer.

However, please note that it is currently the summer vacation period, and many of our engineers are away. Therefore, response can take a long time. My apology for the inconvenience.

Regards,

Hieu

[Hieu]

Hi Joon,

It seems like the numbers in our Product Specification are calculated a long time ago and it might take a while to track down their history. However, I will be out of office from today and for a few weeks. As such, I have to set that aside and refocus back to our initial goal.

I reviewed the calculation in the ticket you link, however, I don't see the basis of some calculation steps, such as the + 0x800 or the & 0xFFFFF000 parts(*), so I cannot comment on its validity. However, the values calculated from their equations seem really close to the value in our Product Specification. Thus, I think you could use their formula as a basis to get a first value. From then, you can tweak the value and monitor the communication on an oscilloscope until the baud rate is exactly as you desired.

What do you think about that suggestion?

As mentioned, I will be out of office, but please feel free to follow-up, and one of our engineers will continue to support you in my stead.

Regards,

Hieu

Note*: So I can guess the + 0x800 is for rounding, but then why & 0xFFFFF000 in the first place?

[Joon Kim]

Hi Hieu,

That's great suggestion, Thanks for that.

Actually I believe in source code, not a product specification, no worries.

I tested 111111 baud rate,

The register value is come out 0x01C72000 based on the post, so added NRF_UART0->BAUDRATE = 0x01C72000 after uart_init();

It worked fine with the 111111 baud device while 115200 baud failed to communicate. I didn't measure the precise timings with a scope but that's enough.

Thanks for the support and have great vacation.

Joon