nPM1300-EK No response from PMIC

[robsrick]

Hi

I connected up the nPM1300-EK with nPM PowerUP v0.9.1 and it said a firmware update was required. This ran successfully and upon reconnection i get the following: 

The LED in the corner next to the USB C Port is flashing every half second or so. How do i recover the device?

[SwRa]

Hi Rob,

Sorry for the delay.. We were a bit short staffed owing to the vacation season here. Could you tell me if the LED on it is toggling on/off.? Could you try pressing SW1.? Could you also check if the PMIC has power.?

Regards,

Swathy