Hello,
I am trying to view a thread network using nRF Thread Topology Monitor via the NRF52840-dongle. When I open the program, I am able to select the dongle from the "Select serial port" dropdown. But, when I start to scan I get an error stating: "Error - No response from Thread CLI device." I was wondering if there is something I am doing wrong.
thanks
Hi,
Use the nRF Connect for desktop programmer app, and program the nrf52840_xxaa_mbr_pca10059_usb.hex to the dongle.
After it has been programmed with the firmware, try again in the nRF Thread Topology Monitor app.
Hi,
Use the nRF Connect for desktop programmer app, and program the nrf52840_xxaa_mbr_pca10059_usb.hex to the dongle.
After it has been programmed with the firmware, try again in the nRF Thread Topology Monitor app.
