NRF_BREAKPOINT_COND

[Nima64]

Hi there.
I've got some problem when advertising has start.
once I turn it on it's happened always after 3 minutes.
Hardware:
I am using nrf52832 module without any EVAL board at all.
all pins configured as output pin except RX,TX,RTC and CTS.
RX and CTS pins has been pulled-up with 4.7K Ohm resistors.
P13,P14,P15,P16 pins configured as input and internal pulled-up resistor activated to them.
P9,P10 configured as output too. but I could not see any action on those pins. (I think it's happened because of the SDK_CONFIG using those pins as a NFC)
Software:
I'm using NRF-SDK V17.0.2,V17.1.0,V15.3.0.
in CMSIS Configuration section the psb-btn-ble has been disabled to pervent any conflicting in pin configuration.
in all these versions I have same problem.
I've got this error code 0x00002006 and cannot find any mean of this.
in any cases that I am using this software I've got same problem.
even without any configurations on default SDK after 3 minutes it's stopped.
Apologies for my weak English.

[Karl Ylvisaker]

Hello,

Apologies for my weak English.

No need to apologize - I will just ask if anything is unclear! :) 

I'm using NRF-SDK V17.0.2,V17.1.0,V15.3.0.

Here you mention three different SDK versions - which is the one you are developing with?
I would always recommend using the latest if starting a new project, and if you have not already done so I would also recommend considering moving to the nRF Connect SDK since this is our newest SDK. Please see this statement regarding the future of these SDKs.


From your ticket it seems that you are encountering the NRF_BREAKPOINT_COND when stepping through the code in the debugger, is this correct?
If so, please make sure to add DEBUG in your preprocessor defines like shown in the included image:

This will make your logger output a detailed error message whenever a non-NRF_SUCCESS error code is passed to an APP_ERROR_CHECK.
Please do this, and let me know what this error message reads, and which line of code it points to in your application.

Best regards,
Karl

[Nima64]

Karl Ylvisaker said:

Here you mention three different SDK versions - which is the one you are developing with?

all three of them has been tested. first with 17.1 and then test older sdks.