Production test

[Joerg]

Hi,

we are using a nRF51822 built into an industrial sensor device. As part of the final production test we want to check the RF connection between the BLE chip and a test system. To keep the production test system as simple as possible we decided just to check if the BLE chip sends advertising telegrams after power up and not to establish a bidirectional BLE connection.

Is in your opinion such a test-strategy sufficient for production-testing of the BLE hardware (nRF-chip, balun, antenna)?

regards Joerg

[run_ar]

That might be ok, however I would recommend reading our application note on how to set up production testing using dtm, this is available here.