Debug cables for Thingy 53 using J-link and/or 52840DK

Hi there,

Making a switch into 53 and order a couple of Thingies. Some questions on debug and probing.

  1. There's a 10-pin small-pitch port on the front right of the device. Can anyone suggest cables I need to get to do SWD/RTT flashing/debugging? I have a Segger J-Link but also a 52840/33DK lying around which I can use? Documentation could use a hint here what to purchase.

  2. The PCA64142 current measurement & debug board is a bit mystical. Searching for it will show the older model but nothing specific. Since there's also a port there with 20-pins and a key. This is probably something I can use for debug, but again which cable do I need and how to connect it?

Thank you for time,
regards,
Martijn 

Related