Suggestion: Nordic MCU without the radio

[ecorm]

This is not a support request, but merely a suggestion to the company. I need a host MCU for my project which will use an nRF52-based pre-approved module. I would like to use a second nRF52 as host MCU with the radio disabled for the following reasons:

• Can use same VS Code toolchain for both the module and host MCU
• Familiarity with nRF52 product family can be applied to both module and host MCU development
• Can re-use the same code for serial communications between module and host MCU

I was considering the nRF52832 for my host MCU, but it is severely lacking in UART peripherals: it only has one!

A Cortex-M4F MCU from a competitor that costs about the same has way more peripherals available for the same pin count. This is not surprising, as this competing product does not include a radio taking up silicon real estate.

So I'm thinking: wouldn't it be nice if Nordic had a Cortex-based MCU without the radio?

[Turbo J]

UART is not a good choice for the MCU-to-MCU communication since its slow and you cannot really shut down the HF clock unless you use more pins.

I recommend using SPI (SPIS+SPIM) instead.

There are NRF52x and NRF53X chips with >1 UART(E) available.

Note that its usually cheaper to use a bigger MCU like NRF53x instead of 2 smaller ones.

[ecorm]

One advantage of using UART for the MCU-to-MCU communication is that it's easier to test the slave MCU using a PC. In my case, I don't need high throughput. My application is a kind of "smart" remote control.