nRFgoStudio : LIBEAY32.dll

[J.Ruckdeschel]

Hi,

I have just installed the lastest nRFgoStudio 1.16.0.3031 (Win32 version under Win7) and when I start the studio the following error commes up :

nRFgoStudio.exe - Ordinal Not Found The ordinal 4540 could not be located in the dynamic link library LIBEAY32.dll

The studio then starts and the nRF51 Eval board (PCA10001) with Segger Nr. is shown but I can do nothing then, the board (chip) is not recognised.

When I use the Master dongle PCA10000 all works fine.

What can I do ?

best regards

Jürgen

[Josh Blackann]

I too am having a similar issue. When I try to launch nRFGo Studio, I receive the following error: "The Ordinal 3239 could not be located in the dynamic link library LIBEAY32.dll".

I updated to the latest version of nRFGo Studio, version 1.17.1 (Win 764 bit PC) and went through the complete install and it did not seem to resolve the issue. For the most part I have been able to still use nRFGo Studio to do what I wanted but now I cannot see any of the nRFGo Motherboards inside nRFGo Studio. The boards show up in Device Manager but the application does not seem to see them.

I am having problems loading code from Keil when using the nRFGo Motherboard. I keep getting "Error: Unable to initialize target." I have tried a couple different nRFGo Motherboards as well as rebooting my machine.

[Larry Affelt]

I am having a similiar problem except its looking for ordinal 2578. I am also on Win7 64, maybe its a Win 7 problem?