Hello,
I've been working with both the nRF 9160 and nRF 9161, with checking/testing the RF of TX.
I have been successful in using AT commands to test 9160, with this command: AT%XRFTEST = 1,1,5,8300,17,0,3,12,0,0,0,0,0
(example from the infocenter.nordicsemi.com)
I also connected to a spectrum analyzer to verify I am getting my expected 830 Mhz. (I am 
)
However, I haven't been as successful with 9161. I used the same command and receive the message 'error' no error code, just 'error'.
I've done a bit of research, and it seems that only RX testing is available for nRF 9161 with AT Commands.
My question is, is there a tool to verify the RF of TX on nRF 9161 with or without AT Commands?
Or when should I expect support for Testing TX on nRF 9161?
My last question, how could I verify if I have the PTI installed on the board or where could I find the PTI to then install it on the board? (As it seems that it does have the test command for TX)
My resources:
- nRF91x1 Cellular at Commands : https://infocenter.nordicsemi.com/pdf/nrf91x1_cellular_at_commands_v1.0.pdf
- nRF91x1 Production Test Image AT Commands : ://www.nordicsemi.com/-/media/Software-and-other-downloads/SiP/nRF91x1-SiP/nrf91x1_pti_at_commands_v0.8.pdf
The image below just shows the error message
.
