nRFgo Studio cann't update the firmware via UART

[Alice]

Hi,

I use the UART to do the device firmware update and have used the dfu_dual_bank_hcl to compile.I use the nRFgo Studio V1.16 to program the s110_nrf51822_5.2.1_softdevice.hex and bootloader.Then I can see the LED1 is lighted.I put the *.hex document at C:\NewFirmware and load it via nRFgo Studio,use the default baud rate and enable flow control.but it cann't update the firmware and stay at the status(as attached).

I also use the CMD to do it:hci_dfu_send_hex.exe -f C:\NewFirmware\ble_app_hrs.hex -p COM 1 -fc -b 38400. But I still cann't update the firmware.

Could you give me some advice?Thanks.

Alice

cmd.JPG

bootloader_hci.JPG

[Alice]

Hi Hung Bui,

Thank you so much for your reply.
Yes,I do the setup on the 6310 as the image you attached.I do the test on Windows XP 32bit and we donn't have Windows 7.

Thank you for your test and I also try to find other machine to do the test.Thanks.

Look forward to your good news.