Connected Device showing, but its Details not showing in vs code

[Akash_91]

I am using nRF connect for VS Code, and I have installed all the required toolchains, software, extensions, and all. 

I am using nRF7002 DK. and doing exercise 2 from https://academy.nordicsemi.com/courses/nrf-connect-sdk-fundamentals/lessons/lesson-1-nrf-connect-sdk-introduction/topic/exercise-2-1/ this course. I have followed all the steps. 

there is a device showing in the connected devices tab. 

but when I click the expand button to see details, it does not show and says " cannot read properties of undefined (reading 'find')

I can't flash the code to the board until the details show. 

I need help with the connected device is showing but when expanding it to view details, it's giving an error.  " cannot read properties of undefined (reading 'find')

[Menon]

Hello Akash,

I don't see an nRF device inside the device manager. Please make sure you have installed the nRF command-line tools properly.

If this has already been installed, please go through the steps mentioned on the below page:

https://wiki.segger.com/J-Link_shown_as_generic_BULK_device_in_Windows

Kind Regards,

Abhijith