• State Verified Answer
  • Locked Locked
  • Replies 6 replies
  • Subscribers 73 subscribers
  • Views 3663 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 110899
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

nrf51 (spim) <-> sd card

Stanislav Silnitskiy

Hello! Do I need any extra passives, connecting SD card to SPIM of nRF51? It works fine with MOSI, MISO, SCK, SEL, VCC and GND directly connected, just want to be sure it will not surprise me one day.

Parents
  • 0

    From reading various sources on the internet it seems that you should use pull-up resistors on all logic lines, or else some SD cards may not work. This is because the lines are floating when the SD card is not inserted or when the nRF chip boots up. Using pull-up on all pins seems to be a part of the SD card spec (have not confirmed this).

    Adding pull-up resistors in the layout will not do any harm since you can choose to leave them unconnected. They will take up space however.

  • 0 in reply to Ole Bauck

    Thank you, Ole, I think to put some on-board if space will allow it. It worth to have this kind of protection.

Reply Children
No Data
Related
Terms of service