Boards getting bricked

[Niels Redegeld]

Hello,

I am trying to develop using a custom pcb. And after some time my boards stop connecting to the debugger. How do I unbrick the boards? I have read multiple solutions like connecting pin 18 to vdd which did not work. When I run nrfjrog --reset I get the following error message: 

[error] [ Worker] - An unknown error.
[error] [ Client] - Encountered error -102: Command connect_to_emu_with_snr executed for 221 milliseconds with result -102
ERROR: Unable to connect to a debugger.
ERROR: JLinkARM DLL reported an error. Try again. If error condition
ERROR: persists, run the same command again with argument --log, contact Nordic
ERROR: Semiconductor and provide the generated log.log file to them.
NOTE: For additional output, try running again with logging enabled (--log).
NOTE: Any generated log error messages will be displayed.
PS C:\Program Files\Nordic Semiconductor\nrf-command-line-tools\bin>

I know it has something to do with reset pins or something, so I will be defining the reset pin in my boardfile, but does that fix the issue or is there a better fix.

Kind regards,

Niels Redegeld

[mathiaso]

Hi, Niels.

Have you tried running "nrfjprog --recover" instead of "nrfjprog --reset"?

Best regards,
Mathias

[Niels Redegeld]

Hi

I have tried running that as well. It gave the same error unfortunatly.

Kind regards,

Niels.

[mathiaso]

Ok. Could you please provide some details on the following?

• Version of nRF command line tools
• What kind of debugger you are using
  • It may be an idea to update the firmware version of your debugger.
• Schematic of your custom board and the connection between your debugger and custom board
• Output log (add --log at the end of the command)

[Niels Redegeld]

I use version 10.24.0
The debugger I use is the J-link edu mini
I think it already has the latest firmware

The schematics are added as a pdf file.

PS C:\Program Files\Nordic Semiconductor\nrf-command-line-tools\bin> nrfjprog --recover --log
WARNING: Logging is unavailable. nrfjprog.exe does not have write
WARNING: permission for the log file
ERROR: Unable to connect to a debugger.
ERROR: JLinkARM DLL reported an error. Try again. If error condition
ERROR: persists, run the same command again with argument --log, contact Nordic
ERROR: Semiconductor and provide the generated log.log file to them.
PS C:\Program Files\Nordic Semiconductor\nrf-command-line-tools\bin>

I dont think this helps much.

BLE_BreadBoard_Schematic (2).pdf

[mathiaso]

Thank you, Niels.

Do you know if you have enabled the DC/DC regulator in the firmware? If this is done without having included the necessary inductors in the schematic, the regulator may become unstable and not be able to deliver sufficient voltage to the SoC.

[Niels Redegeld]

I did not manually enable the DC/DC regulator in the firmware.

[mathiaso]

Ok. Are you using nRF5 or nRF Connect SDK?

Has anything in the firmware changed since you were able to flash the boards? And how many boards have stopped being able to connect vs. still being able to connect to the debugger?