Hello All,
I'm currently now on the initial phase of development and i wanna to stream 2xIMU data through SPI as for now if i connect only one IMU as Follow
P1.15 SCL
P1.14 SD0
P1.13 SDA
P1.12 SC
I can get the data but , If i change these pins in my overlay file by configuring other pins which support SPI i can't get any data through the serial terminal. as per the datasheet the nrf5340 can support up to 4 SPI controller.
-
SPI0:
- MOSI (Master Out Slave In): P0.11
- MISO (Master In Slave Out): P0.12
- SCK (Serial Clock): P0.13
- CSN (Chip Select): Configurable, any available GPIO pin can be used
-
SPIM1:
- MOSI: P0.22
- MISO: P0.23
- SCK: P0.24
- CSN: P0.25
-
SPIM2:
- MOSI: P0.26
- MISO: P0.27
- SCK: P0.28
- CSN: P0.29
-
SPIM3:
- MOSI: P1.00
- MISO: P1.01
- SCK: P1.02
- CSN: P1.03
Could you please advise me what is the problem ??
Regards,
Fabrice