case about nRF9160 example serial_lte_modem GPIO_AT_commands about P0.26 P0.27

[peter.min]

Hi,

1. In ncs v2.6.0 example serial_lte_modem, the level of the P0.26 P0.27 I/O port on the PCA10090 DK board is measurement  0V or 0.8V . Set the high level, normal should equal the VDD voltage 3.0V ,What causes the inconsistent external measurement voltage after the AT instruction is set here?

2. The following changes were made: Cut DK slats SB11 SB12 To modify the serial_lte_modem routine, remove the RTC CTS port with port P0.27P0.27 as the serial port, and disable serial flow control.

3. The command is as follows:

AT#XGPIOCFG=1,26
AT#XGPIOCFG=1,27
AT#XGPIO=0,26,1
AT#XGPIO=0,27,1

4.debug View the configuration of the GPIO0 register as follows:

Thank you for all your assistance.
Kind regards,
Peter.Min

[peter.min]

HI Didrik Rokhaug,

1. No other DKS have been tested
2. Because this is the only DK I have.

3.The routine I provide can be directly compiled and tested, can you test it?

Thank you for all your assistance.
Kind regards,
Peter.Min

[Didrik Rokhaug]

Have you tried to set the pin low?

I have tried to reproduce it, though I have used the pins for UART1, and used the board controller to disconnect the pins from the interface MCU (that way I don't have to cut the solder bridges). I get some voltage initially (though not the expected 3V), and if I set them low, I get 0V. However, after that, I am not able to get any voltage out of them.

It would be interresting to see if you get the same.