Hi
I am facing this issue were I need but 1v8 and 3v3 at the same time to power PPG sensor and it's LEDs
so if there any example code for this approach pls share.
Best regards
Karthik
Hi
I am facing this issue were I need but 1v8 and 3v3 at the same time to power PPG sensor and it's LEDs
so if there any example code for this approach pls share.
Best regards
Karthik
The NRF52840 has only one VDD rail for the GPIOs, thus you have to decide on which voltage to run the chip.
The other hardware has to be put behind some level shifters.
Its too early for source code - you need a schematic first.