External GPS antenna for nRF9160dk

Hi, i've been trying to use gnss function indoors and therefore i need to install an external antenna on my nrf9160dk.

I've read the requirements but i'd like some professional help choosing between two antennas that i believe can be used for my case.

here's the datasheet of the antennas i chose :

 Echo_2_Rev_1_6_1-2930478.pdf (mouser.fr) 

2861064.pdf (farnell.com)

thanks in advance,

kind regards,

Parents Reply Children
  • Hi,

    Not sure if that has the correct connector. In any case you should really direct this question to your distributor. They will be able to help you find the correct antenna from their supply.

    regards

    Jared 

  • Hi,

    my supplier informed me that the SWF RF connector isn't intended to be used to hook up an external antenna, is there another way to improve the GNSS module results in order to get a fix indoors?

    Thanks in advance,

    regards,

  • Hi,

    On that specific antenna that you asked about or in general? The SWF connector on our DK is specifically made to enable external antennas to be connected to the DK.

    In general getting a fix indoors is hard, and there is really few improvements that you could implement except for using a bigger and better antenna.

    regards

    Jared 

  • Hi,

    here's the response i got from my supplier "The SWF RF connector isn’t intended to be used to hook up an external antenna, it’s there to hook up a test probe adapter to measure power during operation." 

    and this got me really confused, i'd really appreciate it if you can help me finding an external antenna that i can use.

    regards,

  • Hi,

    Not sure what the supplier was referring to but: 

    From nRF9160 DK Antenna interfaces documentation:

    The nRF9160 DK has three antenna interfaces for Long-Term Evolution (LTE)Global Navigation Satellite System (GNSS), and the 2.4 GHz radio.

    The LTE and 2.4 GHz RF signals are propagated through two coaxial connectors with switches that can be used to disconnect the corresponding antenna from the radio if adapter cables are connected. This makes it possible to perform conducted measurements or to attach external antennas to the radio.

    The GNSS signal is RX only. A Low-Noise Amplifier (LNA) with integrated filters amplifies and filters the signal before it is fed to the GNSS RF port on the nRF9160 DK. An external active GNSS antenna can be connected to J2. When using an external antenna, the LNA should be disabled.

    The DK has the following antenna interface connectors:

    • J1 – Connector with a switch for the LTE antenna (A1)
    • J2 – Connector for an external GNSS antenna
    • J3 – Connector with a switch for the 2.4 GHz antenna (A3)

    For more information on the GNSS antenna interface, see GNSS.

     

Related