Programming Softdevice by using Lauterbach

[Elena]

Hi everybody

Since quite a long time since my last visit here. Now I come back because a new project using the NRF51822. Because now I'm using the NRF51822-CEAA, I can't program it by using my SEGGER J-LINK Lite. Looks a voltage problem: Segger J-LINK uses 3.3V, but my board (custom) uses 1.8V. See this thread: devzone.nordicsemi.com/.../

So, I'm not able to program the chip right now. I'm thinking to buy a J-Link PRO, but before to buy it, I would like to try to program the chip by using a Lauterbach debugger and T32. Is it this possible? How could I to program for example the Softdevice? Sometimes I've tried to program the softdevice+application+bootloader in a singe binary file by using the NrFGo Studio but with no success.

Any idea or suggestion???

Thanks in advance

Regards,

Elena

[RK]

I have no clue about Lauterbach or T32 - however if you are non-commercial, a JLink-EDU works just fine and is relatively inexpensive, and works down to 1.8v and it comes with all the goodness, support and infrastructure you'd expect from Segger - ie it saves you a whole load of time.

[Elena]

Hi. Finally the problems were related to a HW problem with my board. I've been testing with other board (custom) and it is working correctly. To program the SD I have created a script which copies the SD binary before writting the app binary.

If you need, I have no problems to share my script.

Thanks for your help

Elena