This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Serial(hci) Bootloader brick during Softdevice update, if Image CRC validate fail

Am using SDK 8, Single or dual bank serial bootloader brick during SoftDevice upate. Brick happens only if softdevice CRC validate fails(Stop Cmd). During CRC validate pass case every thing runs smooth.

For Application update this issue is not seen in pass/fail CRC validate case.

0 Stefan Birnir Sverrisson over 9 years ago

Hi Daniel. I suspect you are getting support from Vidar on your case in Nordic's support portal, am I correct? If so, I suggest you close this case here
Cancel
Vote Up 0 Vote Down

Cancel
0 Daniel Abraham over 9 years ago

Yes, Vidar is supporting on this issue.
Cancel
Vote Up 0 Vote Down

Cancel