Hello
I'm using SDK v2.4.2 zephyr
Can I reconfigure the pin instead of using the overlay class?
Hello
I'm using SDK v2.4.2 zephyr
Can I reconfigure the pin instead of using the overlay class?
Hello,
It is possible to make the changes directly in the dts file. But is always better to do this in the overlay since it will overwrite the dts file while retaining the original configuration.
Regards.
Swathy
Thank you for your reply
Can we change that gpio from input to output state (or from spi to i2c...) while the program is running or edit it directly in the dts file and then flash the program to the hardware?
Thank you for your reply
Can we change that gpio from input to output state (or from spi to i2c...) while the program is running or edit it directly in the dts file and then flash the program to the hardware?