UART Prompt is not shown in ZigBee Weather Station App in Thingy53 I can't send any CLI Commands to board (but is shown in Matter Weather Station App)
UART Prompt is not shown in ZigBee Weather Station App in Thingy53 I can't send any CLI Commands to board (but is shown in Matter Weather Station App)
Hi,
Please try to use the latest NCS version v2.6.1 or this image zigbee_weather_station_v261.zip (see Updating through USB).
Are you able to see it now in Device Manager Should be similar to this:
What terminal tool are you using? Have you tried different serial terminals? e.g. PuTTy, Termite, etc.
What is the HW version of the Thingy53 (check the white sticker) on the board? (It may be covered under the NFC tag)
Regards,
Amanda H.
Are you able to see it now in Device Manager? Should be similar to this:
No, when i using zigbee_weather_station_v261.zip
Hi,
NCS v2.7.0 was released last week. Could you try to build NCS v2.7.0Thingy:53: Zigbee weather station and use dfu_application.zip under build\zephyr to update? See the Updating through USB section in the Getting started with Thingy:53 guide for the detailed procedures on how to program the Thingy:53 using nRF Connect Programmer.
-Amanda H.
Hi,
NCS v2.7.0 was released last week. Could you try to build NCS v2.7.0Thingy:53: Zigbee weather station and use dfu_application.zip under build\zephyr to update? See the Updating through USB section in the Getting started with Thingy:53 guide for the detailed procedures on how to program the Thingy:53 using nRF Connect Programmer.
-Amanda H.