52840 Dongle，ble sniffer set coded phy failed

[zadme]

Hello, when testing the BLE sniffer with an nRF52840 dongle (utilizing the most recent official sniffer firmware), I configured Wireshark to capture the coded PHY. After initiating the sniffing process for several seconds and capturing roughly tens of broadcast packets, Wireshark ceases to update data. Upon conducting lower-level debugging, I discovered that the sniffer exclusively outputs counts rather than continuing to output broadcast packets. Could this be attributed to a misconfiguration or are there alternative explanations?

[Edvin]

Hello,

the sniffer exclusively outputs counts rather than continuing to output broadcast packets.

What do you mean by this? What kind of counting are you seeing? 

What sort of packets are transmitted using CODED_PHY? Advertisements, or are you changing over to coded phy after entering a connection?

Best regards,

Edvin

[zadme]

i set this, scan coded phy

flow to thousands of packets and no longer refresh, this phenomenon occurs every time

[Edvin]

So you are only sniffing advertisement packets, no coded phy packets? 

Does it happen regardless of whether you check the box that says "Scan and follow devices on LE Coded PHY"?

Best regards,

Edvin

[zadme]

If I don't select coded phy, the sniffing will continue and broadcast packets will be received continuously

[zadme]

In my requirements, the device sends out a broadcast that has been encoded phy. Before stopping the refresh, I can also receive broadcast data packets that meet the requirements, but it will soon stop refreshing the data

[zadme]

Hi, please help me look at this issue